Flashing for Construction La Plata MD

Most of the water that enters masonry walls in La Plata gets in at the parapet, roof, and windows. So it's critical that all these spots be flashed properly. To prevent water damage, the entire masonry wall must be designed as a system. Here are tips for flashing a typical masonry wall from top to bottom.

Mr. A.C. Inc.
(301) 932-0900
4395 Lady Trisha Ct.
Pomfret, MD
 
Rent-A-Crane Inc
(703) 550-7097
7905
Lorton, VA
 
Kilpatrick Contractor
(571) 389-0798
5604 Vine St
Alexandria, VA
 
LHI & Design
(703) 401-3141
6537 Riefton Ct
Alexandria, VA
Services
Architectural design / residential construction
Prices and/or Promotions
Free design plus permit drawings if awarded construction contract

J E S Construction Inc
(301) 790-0446
6830-B Putman Rd
Thurmont, MD

Data Provided by:
El Progreso Construccion Masonry works
(240) 765-9158
3620 stonesboro road
fort washington, MD
 
LHI DESIGNS
(703) 401-3141
6537 riefton ct.
alexandria, VA
 
LHI & Design
(703) 401-3141
6537 Riefton ct.
Alex., VA
Services
Architectural plans and permits, constructions and design

Baileys Industries
(301) 916-5140
Po Box 4166615 S. Frederick Ave
Gaithersburg, MD

Data Provided by:
Artitech Construction
(301) 519-6997
7809 Breezy Down Ter
Rockville, MD

Data Provided by:
Data Provided by:

Flashing for Construction

Provided By:

Source: Masonry Construction
Publication date: March 1, 1991

By Christine Beall

Abstract: Most of the water that enters masonry walls gets in at the parapet, roof, and windows. So it's critical that all these spots be flashed properly. To prevent water damage, the entire masonry wall must be designed as a system. Here are tips for flashing a typical masonry wall from top to bottom.IN THE PARAPETExposed on both sides, parapets face severe exposure to wind-driven rain. Parapets are thus a primary source of water entering the wall. To prevent water entry, cap parapets with a cast stone, natural stone, terra-cotta, or metal coping. Slope copings so they drain toward the roof. Place through-wall flashing in the bed joint immediately below the coping or metal cap.AT SHELF ANGLESAt the roofline, install a shelf angle and flashing to separate the parapet from the wall below. Flashing should also be installed at each shelf angle throughout the height of the wall. Extend the flashing from the backup through the exterior wythe. To allow moisture to escape, in the first course above the flashing install weep holes in the head joints every 2 feet on center. It takes both flashing and weep holes to make the system work.LINTELS AND SILLSWhenever possible, set windows and doors back from the face of the wall. This creates a drip that keeps rain off the sealed joint between the window head and lintel. It also creates a shadow line to hide the flashing.

Click here to read full article from Masonry Construction

Local Events

Archiving 2009
Dates: 5/5/2009 – 5/8/2020
Location:
Crystal City Hilton Arlington
View Details