How Masonry Buildings Resist Earthquakes Alexandria VA

Because masonry buildings usually have many structural wall elements, they tend to be stiff laterally. Because masonry buildings in Alexandria are stiff laterally, even moderate earthquakes can subject them to large shear loads at their base.

Tech Painting Co., Inc
(703) 684-7702
1406-B Leslie Ave.
Washington, DC
 
MarcParc Inc
(202) 464-2900
1233 20th St., NW
Washington, DC
 
Broncos Drywall
(202) 391-1767
4713 Montgomery Pl
Beltsville, MD
Services
drywall contractor, drywall installation, drywall repair, drywall, remodeling contractor, kitchen remodeling, bathroom remodeler, home remodel, house painting, and painting contractor.
Hours
8:00 a.m. - 5:00 p.m. Mon - Fri

David Barco Plastering Inc.
(757) 650-7928
3441 Saint Clair Drive
Chesapeake, VA
 
Sielic - Key Drywall - Drywall Finishing
(540) 295-9301
271 Wood Landing Rd
Fredericksburg, VA
Services
General Contractor, Dry Wall Contractor, Home Improvements, Painting Contractor, Drywall Finishing
Hours
9am - 5 pm

Handyman Services of Northern Virginia
(703) 237-0390
2850 Greenway Blvd
Falls Church, VA
 
MidPark Services
(202) 462-1204
55 Quincy Pl., NW
Washington, DC
 
Ceilings & Walls Drywall
(757) 236-5857
Kenny
Newport News, VA
 
Richard Hanvey Sheetrock and Plaster Services
(804) 855-4937
7625 Pine Lane
Amelia, VA
 
Ace Drywall & Plastering
(804) 218-6754
605 Milton St
Richmond, VA
Services
dry wall contractor, drywall installation, plastering contractors, drywall repair, plastering service
Hours
Mon-Fri: 9:00AM - 5:00PM

How Masonry Buildings Resist Earthquakes

Provided By:

Source: Masonry Construction
Publication date: January 1, 1990

By Richard E. Klingner

How vulnerable are masonry buildings to earthquakes? How can they be designed to resist earthquakes?

HOW MASONRY BUILDINGS RESPOND

Because masonry buildings usually have many structural wall elements, they tend to be stiff laterally. Because masonry buildings are stiff laterally, even moderate earthquakes can subject them to large shear loads at their base.

For a typical masonry building, these shear loads can be calculated in the following way: Base shear load= (building mass) x (earthquake ground acceleration) x (dynamic amplification factor).

MASONRY SEISMIC DESIGN

Though even moderate ground accelerations can subject masonry buildings to large shear loads, masonry buildings can still be designed to resist these loads. In general, the designer must estimate the lateral inertial forces acting on each element and provide for the transfer of these forces down to the foundation.

INELASTIC RESPONSE OF MASONRY BUILDINGS

A masonry building's earthquake resistance has been described here as a function of wall layout, wall area, and wall strength. These characteristics are often sufficient. Enough wall area can often be provided so that even during a strong earthquake the building's walls remain basically elastic, without any yielding of reinforcement. However, architectural constraints may limit the wall area that can be provided.

Click here to read full article from Masonry Construction