Walls Reinforcement Hagerstown MD

In masonry in Hagerstown walls built in one-third bond rather than conventional running bond, there are places in the wall where the overlap between units is less than 1/3 the length of the unit. As the overlap is reduced, I think the walls would function more like stack bond masonry rather than running bond.

Appalachian Nurseries
(717) 597-0066
Waynesboro, PA
 
Patios Today
(301) 271-7808
14818 N Franklinville Rd
Thurmont, MD

Data Provided by:
G & P Engine Repair
(301) 739-7954
38 W Wilson Blvd
Hagersaintown, MD
 
AG Center Inc
(301) 739-2223
510 East Wilson Boulevard
Hagerstown, MD
 
Carter's Lawn Care
(301) 745-5955
Hagersaintown, MD
 
Meehan's Miniatures
(301) 432-2965
Rohrersville, MD
 
Surreybrooke
(301) 371-7466
8537 Hollow Road
Middletown, MD
 
Frederick Seibert & Association Incorporated
(301) 416-7478
128 S Potomac St
Hagersaintown, MD
 
Fox & Association Incorporated
(301) 733-8504
981 Mount Aetna Rd
Hagersaintown, MD
 
Botanica Services
(301) 745-4644
1185 Mount Aetna Rd
Hagersaintown, MD
 
Data Provided by:

Walls Reinforcement

Provided By:

Source: MASONRY CONSTRUCTION MAGAZINE
Publication date: January 1, 2002

Question: In masonry walls built in one-third bond rather than conventional running bond, there are places in the wall where the overlap between units is less than 1/3 the length of the unit. As the overlap is reduced, I think the walls would function more like stack bond masonry rather than running bond. However, stack bond masonry walls are supposed to be reinforced at the bed joints to prevent vertical cracking.

At what point should these walls be reinforced?

Answer:The Building Code Requirements for Masonry Structures (ACI 530-99/ASCE 5-99/TMS 402-99, Reported by The Masonry Standards Joint Committee 1999) defines running bond as "The placement of masonry units such as that head joints in successive courses are horizontally offset at least one-quarter of the unit length."

In most cases I have seen one-third bond used with 12-inch "jumbo" masonry units, and 9-inch non-modular masonry units. With 12-inch units the overlap needs to be greater than 2-7/8 inches to be considered running bond. For 9-inch non-modular units the overlap must be greater than 2 1/4 inches. When walls are constructed with horizontal offsets less than these figures, bed joint reinforcement spaced at a maximum of 18 inches on center vertically is required.

Click here to read full article from Masonry Construction